Table of Contents
Advertisement
Epson Research and Development
Vancouver Design Center
3 Installation and Configuration
The S5U13L03P00C100 Evaluation Board incorporates a DIP switch, jumpers, and 0 ohm
resistors which allow it to be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13L03 has 3 configuration inputs (CNF[2:0]). A DIP switch (SW1) is used to
configure CNF[2:0] as described below.
S5U13L03P00C100
SW1-[4:1] Config
CNF[2:0] Config
SW1-[1]
SW1-[2]
SW1-[3]
SW1-[4]
= Required settings when using S5U13U00P00C100 USB Adapter board
The following figure shows the location of DIP switch SW1 on the S5U13L03P00C100
board.
S5U13L03P00C100 Evaluation Board User Manual
Issue Date: 2014/05/15
Table 3-1: Summary of Power-On/Reset Options
S1D13L03
CNF0
Host Data lines are normal
CNF1
Host Data is 16-bit
CNF2
PIOVDD output current = 6.5mA
-
not used
Figure 3-1: Configuration DIP Switch (SW1) Location
Power-On/Reset State
1 (ON)
Host data lines are swapped
Host data is 8-bit
PIOVDD output current = 2.5mA
Revision 1.0
Page 7
0 (OFF)
S1D13L03
XB1AG001
Advertisement
Table of Contents
