Epson S5U13700B00C User Manual page 15

Epson Research and Development
Vancouver Design Center
JP6 - Crystal Enable
JP6 is used to enable or disable the S1D13700 crystal output (XCD1).
When the jumper is at position 1-2, XCD1 output is enabled by connecting it to the crystal.
When the jumper is at position 2-3, XCD1 output is disabled by disconnecting it from the
crystal.
Note
S5U13700B00C Rev. 1.0 Evaluation Board User Manual
Issue Date: 2005/07/15
When jumper JP6 is at position 1-2, jumper JP5 must also be at position 1-2.
When jumper JP6 is at position 2-3, jumper JP5 must also be at position 2-3.
Top View
Figure 3-7: Configuration Jumper JP6 Location
JP6
Enable XCD1 output
Revision 1.0
Page 15
Disable XCD1
output
S1D13700
X42A-G-002-01