Installing A Hard Disk Drive In Position 3 Or Position 4; Removing The Disk Interconnect Board - HP C100/110 Owner's Manual

Installing a Hard Disk Drive in Position 3 or Position 4

Perform the following procedure to install a hard disk drive in positions 3 or
4 of the disk tray:
1 Remove the two retaining screws from the disk interconnect board, as shown in
Figure 31
2 Disconnect any cables from the disk interconnect board.
3 Hold the disk interconnect board on the edges and lift it straight up to remove it,
Figure 31.

Removing the Disk Interconnect Board

as shown in Figure 31.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
131