Example 1: Creating A Set Of Video And Audio Ties - Extron electronics CrossPoint 300 84 User Manual

Example 1: Creating a set of video and audio ties

The following steps show an example in which input 5 is tied to outputs 3, 4, and 8.
The steps show the front panel indications that result from your actions.
This example assumes that there are no ties in the current configuration.
Press and release the Esc button (figure 3-4).
1.
Press the Esc button to clear all selections.
CONTROL
ENTER PRESET VIEW
Figure 3-4 — Clear all selections
2. To select video and audio for the tie, if necessary, press and release the
RGBHV button and the Audio button until the LEDs light (figure 3-5).
Press the RGBHV button to toggle on and off.
The LED lights when selected.
Figure 3-5 — Select RGBHV and audio
3. Press and release the input 5 button (figure 3-6).
Press and release
the Input 5 button.
3 4
The LED lights.
Figure 3-6 — Select an input
4. Press and release the output 3, output 4, and output 8 buttons (figure 3-7).
The entire set of ties can be canceled at this point by pressing and releasing the
Esc button. The Esc LED flashes once.
The LED
blinks once.
ESC
I/O
RGBHV AUDIO
Press the Audio button to toggle on and off.
The LED lights when selected.
INPUTS
5 6 7
CrossPoint 300 Matrix Switchers • Operation 3-9