Example 1: Creating A Set Of Video And Audio Ties - Extron electronics MVX VGA A User Manual

Example 1: Creating a set of video and audio ties

In the following example, input 5 is tied to outputs 3, 4, and 8. The steps show the
front panel indications that result from your actions.
N This example assumes that there are no ties in the current configuration.
1. Press and release the Esc button (figure 3-3).
Press the Esc button to clear all selections.
CONTROL
ENTER PRESET VIEW
= LED blinks once.
1
Figure 3-3 — Clear all selections
2. To select video and audio for the tie, if necessary, press and release the
RGBHV button and the Audio button until both the RGBHV and Audio LEDs
light (figure 3-4).
Press the RGBHV button to toggle on and off.
The LED lights when selected.
Figure 3-4 — Select RGBHV and audio
3. Press and release the input 5 button (figure 3-5).
Press and release the Input 5 button.
2 3
Figure 3-5 — Select an input
1
ESC
The LED blinks once.
I/O
RGBHV AUDIO
Press the Audio button to toggle on and off.
The LED lights when selected.
INPUTS
4 5 6 7
The Input 5 LED lights.
MVX VGA A Matrix Switchers • Operation 3-9