Example.1:.Creating.a.set.of.video.and.audio.ties - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd
Example 1: Creating a set of video and audio ties
In the following example, input 5 is tied to outputs 3, 4, and 8. The steps show the
front panel indications that result from your action.
N This example assumes that there are no ties in the current configuration.
1.
Figure 3-5 — Clear all selections
2.
Figure 3-6 — Select RGBHV or video and audio
3.
Figure 3-7 — Select an input
3-14 CrossPoint / MAV Matrix Switchers • Operation
Press and release the Esc button (figure 3-5).
Press the Esc button to clear all selections.
C O N T R O L
VIEW ESC
ENTER PRESET
The button flashes once.
To select video and audio for the tie, if necessary, press and release the
RGBHV (CrossPoint switchers) or Video (MAV Plus switchers) button and the
Audio button until the buttons both light (figure 3-6).
Press the RGBHV/Video button to toggle on and off.
The button lights green when selected.
Press and release the input 5 button (figure 3-7).
Press and release the Input 5 button.
The button lights amber (matrix sizes up to 1616) or
green (matrix sizes 2412 through 3232).
1 2 3 4 5
17 18 19 20 21 22 23 24 31 32
I / O
RGBHV AUDIO
Press the Audio button to toggle on and off.
The button lights red when selected.
I
6 7 8 15 16
N
P
U
T
S