Performing A System Reset From The Front Panel - Extron electronics CrossPoint 300 84 User Manual

Operation, cont'd

Performing a system reset from the front panel

The front panel reset is identical to the rear panel system reset (see "Performing a
system reset from the rear panel" on page 3-39) and to the
command (see chapter 4, "Programmer's Guide"). A system reset:
•
•
•
Reset the switcher to the factory default settings by pressing and holding the
RGBHV button and Audio button while you apply AC power to the switcher
(figure 3-58).
Press and hold the RGBHV and Audio
buttons while you apply power to the switcher.
The switcher's LEDs blink and then go dark.
Continue to hold the RGBHV and Audio buttons until all
input and output LEDs return to the unlit state and the
RGBHV and Audio LEDs turn on.
Release the RGBHV and Audio buttons.
Figure 3-58 — System reset
3-36 CrossPoint 300 Matrix Switchers • Operation
Clears all ties and presets
Clears all video and audio mutes
HVA switchers — Sets all input audio levels to unity gain (+0 dB)
System reset does not replace user-installed firmware upgrades.
I/O
RGBHV AUDIO
ZXXX
Esc
2
1
Power
SIS