Power Save Mode; Stacking Two Projectors - Barco R9004460 Owner's Manual

2. Installation Guidelines
2. Connect the charger to the wall outlet.

2.10.3 Power save mode

Why used ?
When working on batteries, indicated on the main menu as BAT=ACT, the power save mode is enabled if there is no key hit within
2 minutes.
A message will be displayed : "POWER SAVE MODE".
The remote control is automatically switched off after being approximately 10 minutes in the Power Save
Mode. Use the ON/OFF switch to reset the Remote control.

2.11 Stacking Two Projectors

How to handle
1. Turn in the four feet of the second projector.
2. Pull the handler A of the second projector a little backwards. (image 2-19)
3. Put the second projector on the first one so that the base plate of the second projector matches with the rigging socket of the first
projector.
4. Slide the security pin (handler C) into the hole of the rigging socket of the first projector until the handler jumps into its socket (D).
(image 2-20)
Projector 2
B
Projector 1
Image 2-19
Stacking two projectors
C
Image 2-20
Stacking : security lock
W
ARNING
20
A
A
D
:
Close always the four security pins when stacking two projectors on each other.
R59770014 XLM HD30 07/07/2006