Service; Start Up Of The Service Menu; Identification - Barco R9004460 Owner's Manual

8. SERVICE

Overview
•

Start up of the service menu

•

Identification

• Change Projector Address – Common Address
• Communication
• Date and time setup
• Lamp
• Dimming-CLO
• Broadcast mode
• Convergence
• Diagnosis
8.1 Start up of the service menu
How to start up
1. Push the cursor key ↑ or ↓ to highlight Service. (menu 8-1)
2. Press ENTER to select.
The service menu will be displayed. (menu 8-2)
MAIN
Select a path from
below :
ADJUSTMENT MODE
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-1
8.2 Identification
What can be seen on the identification screen ?
The identification screen shows the general information of the projector.
The following items will be displayed:
• Type of the projector.
• Software version
• Configuration, installation of the projector:
- front/ceiling
- front/table
- rear/ceiling
- rear/table
• Baud rate : transfer speed for communication with a computer. The baud rate of the projector must be the same as the baud
rate of the connected computer. When there is a difference, consult 'Change Baudrate' in this chapter.
• Text, message and bar scales can be on or off.
• Projector serial number : indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
• Projector run time : total time the projector is running since its first start up.
Start up
1. Push the cursor key ↑ or ↓ to highlight Identification. (menu 8-3)
R59770014 XLM HD30 07/07/2006
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
BROADCAST MODE [OFF]
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-2
8. Service
99