Barco R9004460 Owner's Manual page 42

4. Getting Started
No. Key name
1 Function keys
2 MENU
3 Address key
4
LOGO key
5
PAUSE
6 STBY
7 TEXT
8 AUTOIMAGE
9 Digit buttons
10 Lens control
11 VOL
12 Picture controls
13
DIGI ZOOM
14 FREEZE
15 PIP
16 ENTER
17 Cursor keys
18 BACK
19 EFFECTS
20 PIP ADJUST
21 RC operating indication
38
Description
not used
Menu key, to enter or exit the menus.
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
Lens adjustment key
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
to deactivate or activate the on screen dialog boxes and menus.
not used
direct input selection.
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
Not used
use these buttons to obtain the desired picture analog level.
not used
press to freeze the projected image.
not used
to confirm an adjustment or selection in the MENU.
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
menu bar.
to leave the selected menu or item (go upwards to previous menu).
not used
window select
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
R59770014 XLM HD30 07/07/2006