Table of Contents
Advertisement
4. Getting Started
No.
Key name
12
Address key
13
Digit buttons
4.3
Switching on the projector
How to switch on
1. Press the tumbler switch in the "1" position ("ON" state indicated by a visible red section of the switch).
-
When "0" is visible, the projector is switched off.
-
When "1" is visible, the projector is switched on.
The projector starts in standby mode. The projector indication LED is red.
Start image projection
1. Press Standby key once on the local keypad or on the remote control.
Note: It may take about 60 seconds before image projection, i.e. no projection until the completion of several operations (soft-
ware initialization, ...).
Note: The identification screen will be displayed during start up.
At startup, the active errors will be displayed on the screen and on the LCD display for a short period of time.
C
AUTION
displayed.
The lamp does not start up if a water cooling error is active.
4.4
Lamp runtime
Lamp runtime indication while running
When the total runtime of the lamp is (1000 - 30) hours or more, a warning message will be displayed.
This warning message will be repeated at the next start up. Press BACK or MENU to remove the message.
The total lifetime of the lamp for a safe operation is 1000 hours maximum, do not use it longer. Always replace with the same type
of lamp. Call a Barco authorized service technician for lamp replacement.
Typical lamp lifetime = 500 hours, maximum lamp lifetime = 1000 hours.
W
ARNING
4.5
Switching to standby
How to switch to standby?
1. Press Standby to switch the projector to standby.
40
Description
to enter the address of the projector (between 0 and 9).
direct input selection.
:
Pushing the standby key too long, might cause the projector to shut down right after an image is
:
Using the lamp longer than its maximum lifetime is dangerous as the lamp could explode.
R59770014 XLM HD30 07/07/2006
Advertisement
Table of Contents
