Show Bridge Address-Table Count - Planet Networking & Communication WGSW-24010 User Manual

Syntax
show bridge address-table static [vlan vlan] [ethernet interface | port-channel port-channel-number]
§ vlan — Specific valid VLAN, such as VLAN 1.
§ interface — A valid Ethernet port.
§ port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, all static entries in the bridge-forwarding database are displayed.
console# show bridge address-table static
Aging time is 300 sec
vlan mac address
------ --------------------
1 0060.704C.73FF
1 0060.708C.73FF
200 0010.0D48.37FF

3.4.15 show bridge address-table count

The show bridge address-table count privileged EXEC command displays the number of addresses present in all
VLANs or at a specific VLAN.
Syntax
show bridge address-table count [vlan vlan]
§ vlan — Specific VLAN.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, the number of addresses present in the VLANs are displayed.
console# show bridge address-table count
Capacity: 8192
Free: 8084
Used: 108
Static addresses: 2
Dynamic addresses: 97
Internal addresses: 9
port type
------ -------
e8 permanent
e8 delete-on-timeout
e8 delete-on-reset
28