Show Radius-Servers; Rmon Commands - Planet Networking & Communication WGSW-24010 User Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example sets a dead time where a RADIUS server is skipped over by transaction requests for this period, to
10 minutes.
Console (config)# radius-server deadtime 10

3.18.7 show radius-servers

The show radius-servers user EXEC command displays the RADIUS server settings.
Syntax
show radius-servers
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays the RADIUS server settings.
Console# show radius-servers
Port
IP address Auth
--------------- -------- -------
172.16.1.1 1645 1646
172.16.1.2 1645 1646
OOB RADIUS servers
Port
IP address Auth
---------------- ------- -------- -------------- ------------------
176.16.8.9 1645 1646
Global values
-------------------
TimeOut: 3
Retransmit: 3
Deadtime: 0
Source IP: 172.16.8.1

3.19 RMON Commands

3.19.1 show rmon statistics
The show rmon statistics user EXEC command displays RMON Ethernet Statistics.
Syntax
show rmon statistics {ethernet interface number | port-channel port-channel-number}
§ interface number — Valid Ethernet port.
§ port-channel-number — Valid port-channel trunk index.
Acct TimeOut Retransmit
-------------- ---------------- ---------------
Global
11
Acct TimeOut Retransmit
Global Global
Deadtime
Global Global
8 Global
Deadtime
-------------
Global
Source IP Priority
--------------- ----------
Global 1
Global 2
Source IP Priority
--------------- -----------
Global 1
Usage
-----------
All
All
101