Qos Commands; Qos; Qo Command; Show Qos - Planet Networking & Communication WGSW-24010 User Manual

Source Port Destination Port
---------------- -----------------------
1/1 1/8
1/2 1/8
1/18 1/8

3.17 QoS Commands

3.17.1 qos

The qos global configuration command enables quality of service (QoS) on the device and enters QoS basic or advanced
mode. Use the no form of this command to disable the QoS features on the device.
Syntax
qos [advanced]
no qos
§ advanced — QoS advanced mode, which enables the full range of QoS configuration.
Default Configuration
By default QoS is enabled in basic mode.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command. However, switching to Basic qos mode sets the trust mode to cos.
Example
The following example shows how QoS is enabled on the device, in basic mode.
Console (config)# qos

3.17.2 show qos

The show qos user EXEC command displays the QoS status.
Type Status
------------
RX, TX Active
RX, TX Active
Rx Active
VLAN Tagging
----------- -------------------
No
No
No
89