Qos Map Dscp-Queue - Planet Networking & Communication WGSW-24010 User Manual

qid status Target Committed
Rate [bps]
1 Enable 100000
2 Disable N/A
3 Enable 200000
4 Disable N/A
5 Disable N/A
6 Disable N/A
7 Enable 178000
8 Enable 23000
The following example displays output from the show qos interface g1 policers command
Console# show qos interface ethernet g1 policers
Ethernet g1
Class map: A
Policer type: aggregate
Committed rate: 192000 bps
Committed burst: 9600 bytes
Exceed-action: policed-dscp-transmit
Class map: B
Policer type: single
Committed rate: 192000 bps
Committed burst: 9600 bytes
Exceed-action: drop
Class map: C
Policer type: none
Committed rate: N/A
Committed burst: N/A
Exceed-action: N/A

3.17.7 qos map dscp-queue

The qos map dscp-queue global configuration command modifies the DSCP to queue map. To return to the default map,
use the no form of this command.
Syntax
qos map dscp-queue dscp-list to queue-id
no qos map dscp-queue
•
dscp-list—Specify up to 8 DSCP values, separate each DSCP with a space. (Range: 0 - 63)
•
queue-id—Enter the queue number to which the DSCP value corresponds.
QoS Commands
qos trust (Global)
Copyright © 2004 Marvell CONFIDENTIAL
January 19, 2004, Preliminary
Document Classification: Proprietary Information Page 147
Default Configuration
The following table describes the default map.
Command Mode
Global Configuration mode
Target Committed Burst
[bytes]
17000
N/A
19000
N/A
N/A
N/A
8000
1000
Doc. No. MV-S200005-00 Rev. C
94