Port Storm-Control Include-Multicast; Port Storm-Control Broadcast Enable - Planet Networking & Communication WGSW-24010 User Manual

Syntax
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset

3.7.19 port storm-control include-multicast

The port storm-control include-multicast global configuration command enables the device to count multicast packets
together with broadcast packets. To disable counting of multicast packets, use the no form of this command.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
Default Configuration
Multicast packets are not counted.
Command Modes
Global Configuration mode
User Guidelines
To control multicasts storms use the commands port storm-control broadcast enable and port storm-control
broadcast rate.
Example
The following example enables the counting of multicast packets.
Console# configure
Console(config)# port storm-control include-multicast

3.7.20 port storm-control broadcast enable

The port storm-control broadcast enable interface configuration command enables broadcast storm control. To disable
broadcast storm control, use the no form of this command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
56