About The Printing/Cutting Area; About The Blade - Roland ColorCAMM PNC-5000 User Manual

Printing with a width of 210 mm or more (using a 4-color ribbon cartridge)
OK
No good

7 About the Printing/Cutting Area

Factory default
Pinch roller (left)
6.5 mm
25 mm (1") or more
(5/16")
..... Printing/Cutting area

8 About the Blade

If the blade becomes dull
When the blade starts to lose its sharpness, try gradually increasing the cutter force.
Increasing the cutter force temporarily allows the blade to perform better. However, once the blade is dull, it is time to replace it.
Average blade life
The life of a blade varies, depending on the amount of cutting it performs.
The total cutting length can vary considerably, depending on the thickness, toughness, and type of adhesive of the cut material. Set an
appropriate cutter force, one that is well matched to the material and the hardness of the blade. This will extend the life of the blade.
Excessive cutter forces can cause the blade to wear out quickly. Care should be taken.
381 mm (15") (maximum printing/cutting width)
210 mm (8-1/4") (length of the ink ribbon)
When DIP switch SW-5 (front
edge sense) is ON (enabled)
Pinch roller (left)
12.5
mm
(1/2")
6.5 mm 25 mm (1")
(5/16")
6 Printing and Cutting Samples / 7 About the
Printing/Cutting Area / 8 About the Blade
Take steps to ensure that the
Ink-ribbon seam
printing data does not overlap
with the ink-ribbon seam
When DIP switch SW-6 (cut
sheet mode) is ON (enabled)
Pinch roller
(left)
12.5
mm
(1/2")
6.5 mm
(5/16")
171 mm (6-11/16")
50 mm (2")
110 mm (4-3/8")
or more
12.5
mm
(1/2")
25 mm (1")
13