Reconfigure A System - Lennox icomfort Wi-Fi Setup Manual

Reconfigure a system

If any component of the HVAC system has been changed, e.g. replacing an
outdoor sensor, reconfiguring the system will be required. To begin reconfi-
guring a system (after you have accessed the program from the Lennox logo
[previous page]), press the setup button (1, figure 34A). The Start system
configuration" screen (fig. 34B) will appear. Press start (2, figure 34B) to pro-
ceed. The Re−configure confirmation" screen (fig. 34C) will appear. This re-
minder notes that system configuration may affect some existing device set-
tings and prompts to confirm or cancel the configuration process.
setup tests
1
Select Devices
System
Furnace
Thermostat
9:39 am Aug 15, 2012
equipment alerts diagnostics
system and device alerts
setup tests
press start button only if you wish to setup a new system,
select all
or to re−setup an existing system
view active
deselect all
view cleared
9:39 am Aug 15, 2012
Figure 34. Re−configuration process
Press confirm (3, figure 34C) to continue system configuration; the screen
will change to the system discovery screen. At this point, the program goes
through the same setup as the initial setup process which begins on
Page 4.
NOTE − Compatible device found" screen (shown below) appears only
when a device has been removed and replaced with a compatible device.
Missing
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
equipment alerts
setup
configuring the system may effect some devices.
2
start
EXIT
9:39 am Aug 15, 2012
icomfort Wi-Fit 7−Day Programmable Communicating Thermostat
Page 29
Found Compatible
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
Settings were not copied
diagnostics
tests equipment
confirm to continue or press cancel
3
back
confirm cancel
EXIT
alerts diagnostics
EXIT