Lennox icomfort Wi-Fi Setup Manual page 42

Parameter Name
Other Parameters
Equipment Name
Continuous Indoor Blower Airflow
Humidification Airflow
Dehumidification Airflow Percentage
Note 1: Minimum Outdoor Unit Cooling Stage as a percentage of High Cooling Airflow (value is rounded up to the closest number on 25 CFM resolution.
Note 2: Minimum Outdoor Unit Heating Stage as a percentage of High Heat Pump Airflow (value is rounded up to the closest number on 25 CFM resolution).
Note 3: All communicating Installer Parameters default CFM values based on DIP switch setting (non−communicating value) are calculated using the CFM conversion
tables and rounded up to closest number on 25 CFM resolution.
Note 4: Parameter dependency − Certain parameters are dependent on others and may not be shown on the display.
Note 5: Default Values − Jumper/DIP switches impact the default value of some parameters.
506920−01 09/12
Table 3. Adjustable Parameters Table (Installer)
Default Min. Max.
Furnace N/A N/A
DIP SW (See Min Max
Note 3 at CFM CFM
end of table)
Min Max
CFM CFM
Same as Min Max
above CFM CFM
Min Max
CFM CFM
140 120 160
(=70%) (=60%) (=80%)
Incr. Dependency
N/A None
25 None
25
25 Humidifier present
25
2 OU present and SC
(=1%) (Subnet Controller)
algorithm support
Page 42
Note Installer entry
Up to 35 characters
1/2 HP blower
1 HP blower
1/2 HP blower
1 HP blower
Percent of High Cooling
Airflow