Adjust A Setting Screen - Lennox icomfort Wi-Fi Setup Manual

Adjust a setting screen (communicating devices)
Use arrows to select a device from the system devices" list; then use the about button to view information (shown on Page 8) about communicating
devices (information about other devices is not available).
Use resetAll button to un−install all non−communicating devices that were added through Add or Remove..." screen and to reset any device settings made
through this Adjust a setting..." screen to the factory defaults. (While editing a communicating device, the reset button is limited to only the selected device.
You are asked to confirm (shown in figure 11) before resetting all.
Use this screen to access communicating devices' settings (pressing buttons numbered from 1 to 6 in figure 11 for an example of changing heating airflow;
more examples are shown on the next page). Use back to return to the previous screen or next to go on. A complete list of parameters, their defaults and
setting ranges, begins on page 37.
system devices
System
Furnace
Thermostat
2 Stage HP Unit
Power (120VAC) Humidifier
Humiditrol
system devices
Equipment Name
Heating Airflow Control Type
Low Heating Airflow
High Heating Airflow
High Cooling Airflow
Airflow Profile − Cooling
High HP Airflow
Continuous Indoor Blower Airflow
To adjust a setting,
highlight it, then press
Edit
Furnace
1
2
Low Heating Airflow
current value:
back
325
3
Figure 11. Adjust communicating device screens
about
resetting a device to its factory default
resetAll
(resetting ALL devices to their factory default)
settings will cause the system to restart the
edit
To continue, press CONFIRM or press CANCEL
next
reset
edit
4
back
icomfort Wi-Fit 7−Day Programmable Communicating Thermostat
Page 13
(if resetAll
is pressed)
setup process.
confirm cancel
Low Heating Airflow
Range is 325 to 450
Default is 400, inc:25
set−to
325
5
save cancel
6