Set Up Equipment Parameters - Lennox icomfort Wi-Fi Setup Manual

After pressing next after the final test, the Testing finished" screen will ap-
pear (figure 20). At this point, use the EXIT button (if you have completed the
required setup), or use diagnostics button (to analyze the system), or use
equipment button (if you wish to make any changes to device details).
setup tests
The Testing Process is finished
press 'tests' button to run more tests
press 'EXIT' button to start normal operation
9:39 am Aug 15, 2012
Figure 20. Testing finished screen
Equipment, Alerts, Diagnostics
Press equipment if you need to set up equipment parameters and edit de-
tails of devices in the system (see Page 20).
Press alerts if you need to run to see any alerts that may present or to view
alerts that have been cleared (see Page 22).
Press diagnostics if you need to run to analyze the system (see Page 21).
506920−01 09/12
equipment alerts diagnostics

Set up Equipment parameters

Press equipment to set up equipment parameters and edit details of de-
vices in the system without having to re−run the setup program. When the
press start..." screen (figure 21A) appears, press start. The Equipment pa-
rameters" screen (figure 21B) will open. You may view information about or
modify communicating devices as described earlier in the setup pages, be-
ginning on page 14. Use the arrows to select a device and press edit.
Use the arrows to highlight a setting and then press edit (figure 22A). In the
example, the low heating airflow is changed from the default (400) to 325 (fig-
ure 22B). After changing, press save. (note the current value has changed;
figure 22C). Some changes may affect other settings and, if so, those af-
fected will appear in red and require changing/saving to clear the red set-
tings.
setup
press start button below to edit details of devices in the system
setup
EXIT
system devices
System
Heat Pump
Furnace
Thermostat
Humiditrol
9:39 am Aug 15, 2012
Figure 21. Equipment parameters screen
Page 20
tests equipment alerts
start
tests equipment
To adjust a setting,
highlight it, then
press Edit
Furnace
diagnostics
back
about
resetAll
EXIT
edit
next