Configure Dehumidifier (Humiditrol®/Aux. Dehum. Installed) - Lennox icomfort Wi-Fi Setup Manual

Adjust a setting... Configure Humiditrol
system devices
System
Air Conditioner
Furnace
Thermostat
Humiditrol
System
3rd Stage Delay
4th Stage Delay
Lock In 2nd Stage HP by Outdoor Temp
Balance Point Control
Humiditrol Comfort Adjust
Min Dehumidification Setpoint
Humiditrol Comfort Adjust
Select one
Maximum Overcooling
Minimum Overcooling
3a
save
Humiditrol Comfort Adjust settings are
only available on units equipped with
®
a Humiditrol dehumidification device.
See Page 18 for description of Min/
Mid/Max overcooling.
506920−01 09/12
®
or Auxiliary Dehumidifier
To adjust a setting,
highlight it,
then press Edit
System
1a
1b
Dehumidification Control Mode
current value:
Midpoint Overcooling
2a
2b
Midpoint Overcooling
back
System
Staged Delay TImers
cancel
2nd Stage Delay
3b
3rd Stage Delay
4th Stage Delay
Lock In 2nd Stage HP by Outdoor Temp
Balance Point Control
Humiditrol Comfort Adjust
Min Dehumidification Setpoint
OD/Humid Boundary
Outdoor Temperature Reading Calibr
9:39 am Aug 15, 2012
Figure 15. Adjust a non−communicating device setting DEHUMIDIFIER
Pre−adjustment REQUIREMENTS:
1st, the device has been installed (see Page 12).
about
2nd, from the Add or Remove Non−communicating equipment?", press next.
3rd, in the Adjust a setting..." screen, configure the device as follows:
1. In the system devices" list, use the arrows (1a) to highlight System. Press
resetAll
edit (1b).
®
2. Humiditrol
edit
Humiditrol Comfort Adjust. The current value defaults to Maximum Over-
cooling. Press edit (2b).
®
3. Humiditrol
reinstall
cooling level; press save (3b). (After saving, check that the current value
now shows the new selection).
4. Use arrows (4a) to highlight Min Dehumidification Setpoint; press edit
reset (4b). Note the current value (e.g. 45).
5. Use arrows (5a) to make changes; press save (5b). (After saving, check
that the current value now shows the new selection).
edit
6. Press the back button to return to Adjust a setting..." screen.
Dehumidification Control Mode
current value:
45
4a
6
back
Page 16
only In the System" list, use the arrows (2a) to highlight
only Touch one of the radio buttons (3a) to select the over-
Min Dehumidification Setpoint
Range is 40 to 60
4b
Default is 45, inc:1
edit
reset
save
5b
(returns to
adjust a
setting
screen)
set−to
5a
42
cancel