Outdoor Unit - Lennox icomfort Wi-Fi Setup Manual

Add Non−Communicating Outdoor unit
System Devices
System
Furnace
non−communicating device list
Outdoor Unit Type
Humidifier
Dehumidifier
Outdoor Unit Type
Select one
Not Installed
2 Stage A/C Unit
2 Stage HP Unit
3a
save
3b
506920−01 09/12
Add or Remove
1
Non−communicating
equipment?
to add/remove/adjust a device,
select it, then press edit
current value:
Not Installed
2a
back
2b
back
1 Stage A/C Unit
non−communicating device list
1 Stage HP Unit
Outdoor Unit Type
Outdoor Unit Capacity
Outdoor Unit 1st Stage Capacity
Humidifier
Dehumidifier
cancel
9:39 am Aug 15, 2012
Figure 8. Add non−communicating device OUTDOOR UNIT
To add (or remove) an outdoor unit that is not icomfortt−enabled, you must be at
the Add or Remove Non−communicating equipment?" screen.
1. Press the yes button on this screen (see 1).
yes 2. In the non−communicating device list" screen, use the arrows (2a) to
highlight Outdoor Unit Type and press edit (2b).
3. Touch one of the radio buttons (3a) to select a 1−or 2−Stage AC Unit or a
1−or 2−Stage HP Unit; press save (3b).
4. Use arrows (4a) to highlight any red colored text in the device list (e.g.
select Outdoor Unit Capacity; text turns white). Press edit (4b).
5. Use arrows (5a) to make changes; press save (5b). Change other red
settings (if present) using a similar process.
NOTE − If the defaults are correct, you do not have to make any changes, but you
must press save (5b). When all red text is gone, the back button will appear; press
it to return to the Add or Remove Non−communicating equipment?" screen (1).
next
edit
to add/remove/adjust a device,
select it, then press edit
current value:
2 Stage AC Unit
4a
please view and save all
red settings
Page 10
Outdoor Unit Capacity
Range is 18 to 60
Default is 36, inc:1
edit
4b
5b
back
set−to
36
5a
save cancel