Other Controls - Datalogic Skorpio X3 User Manual

OTHER CONTROLS

Code
Description
Parameter
Enables/disables
the ability to
Enable Label
perform label
Programming
programming.
Specifies the
symbology
identifier (if any)
that is sent by the
decoder when
parameter Send
Send
Code ID (Index
Symbology
0025) is set to 3.
Identifiers
ASCII code zero
(null) used to
indicate an
identifier not to be
sent for the
symbology.
Character string
sent immediately
prior to

Label Prefix
symbology
identifier
(0=None).
Character string
sent immediately
after final
Label Suffix*
character in data
(0=None).
Character string
sent after each
Label
string in a sample
Separator
where multiple
strings exist.

Only a single character can be programmed with a programming label; strings can only be programmed in the
Decoding control panel applet.
I.D.# Accept. Input
FF00 On or Off
Select symbology
identifier to transmit
immediately preceding
scanned data:
0=None
1=DLM identifier before
label: <ID> " " <data>
2=AIM identifier before
label: "]" <ID>
<modifier> <data>
0025
3=User defined identifier
before label: <ID>
<data>
4=DLM identifier after
label: <data> " " <ID>
5=AIM identifier after
label: <data> "]" <ID>
<modifier>
6=User defined identifier
after label: <data> <ID>
A string of Unicode
0026
characters.
A string of Unicode
0027
characters.
Any single ASCII
0028
character (00 = Off).
Defaults
Enter 1 for On and 0 for Off
On On
00 01
NUL NUL
CR+LF CR+LF
CR CR
Scanner
Type
On √ √
00 √ √
NUL √ √
CR+LF √ √
CR √ √
155