Imaging Controls - Datalogic Skorpio X3 User Manual

IMAGING CONTROLS

Code
Parameter
Instructs the PDT to
illuminate the scanning
Imager
area (independent of any
Illuminate
targeting beam) when using
Enable
an imager.
Toggles between two
different operating modes
for the targeting beam:
Concurrent (Off): The
targeting beam is turned on
Imager Aim
at the same time as an
Mode
enabled illumination beam.
"Release Scan" (On) turns
off the targeting pattern
after trigger release..
Enable the use of a target
beam and enables Pick List
Mode, which decodes only
Enable Aiming
the bar code label
Beam
immediately under the
targeting cross.
154
Description
000A
Accept.
I.D.#
Input
Enter 1 for On and 0 for Off
0008 On or Off
0009 On or Off
On or Off
Defaults
On On On
On On On
On On On
6
Scanner
Type
√
√
√