Programming Codes Without Parameters - Datalogic Skorpio X3 User Manual

PROGRAMMING CODES WITHOUT PARAMETERS

The following table describes the functions of special bar codes that take no
parameters:
Code
Parameter
Defaults
Minimum
Defaults
Maximum
Defaults
Factory
Defaults
Registry
Exit and
Restore
Exit and
Save
Exit and
Commit
I.D. #
Turns every On/Off parameter off and sets all minimum and
FF39
Maximum Label Lengths to the lowest values.
Turns every On/Off parameter on and sets all minimum and
Maximum Label Lengths to the highest values. This default set is
FF3A normally used only for troubleshooting. It gives the best chance of
reading an unknown bar code symbology and also identifies the
symbology of each bar code scanned.
This is the default parameter settings that was installed at the
FF3B
factory. This default set will work for most applications.
This restores all parameter settings to the values that exist in the
FF3C Registry. This is useful for restoring parameters to a known working
set of values which have been saved using code parameter FF3F.
Stops a label programming sequence and restores all parameter
FF3D
settings to the values that exist in the Registry.
Stops a label programming sequence. The last valid parameter
FF3E
settings are left intact.
Stops a label programming sequence and writes all parameter
FF3F settings into the Registry. This can be used to save a customized
set of parameter settings for restoring later via parameter FF3C.
Function
125