Decoding Parameters - Datalogic Skorpio X3 User Manual

DECODING PARAMETERS

This section contains information about programmable settings for the Skorpio X3™.
Use the Skorpio X3™ Management Utility (FMU), the Scanner Control Panel applet,
the Imaging Control Panel applets to program the Skorpio X3™.
It provides the following information:
Code Parameter is the "human" name for the programming option.

I.D. # is the "decoder" name for the programming option. For example, to set a

Code 39 minimum label length, use I.D. 0120. Programming I.D. numbers given
in this appendix can be used with all programming methods. Note that the
Programming I.D. numbers are provided in hexadecimal notation.
Type tells what kind of setting to use for each code parameter.

On/Off is a toggle. 1 turns the parameter on, and 0 turns it off.

Acceptable Input gives the settings or range of settings for each code

parameter.
Defaults indicates how the parameter is set when the predefined default FF39,

FF3A, or FF3B is selected.
Minimum (FF39) turns every on/off parameter off and sets all minimum and

Maximum Label Lengths to the lowest values.
Maximum (FF3A) turns every on/off parameter on, sets all Minimum Label

Lengths to the lowest values, and sets all Maximum Label Lengths to the highest
values. Use this default for troubleshooting; it provides the best settings for
reading an unknown code symbology and can identify the symbology of scanned
bar codes.
Factory (FF3B) is the factory setting installed on the Skorpio X3™. This default

set will work for most applications. To reset the Skorpio X3™ the original
defaults, scan the Factory bar code
Scanner Type shows, with a checkmark, which modules support the

specified parameter.
124
6