Rear Panel
Antenna
One antenna (aerial) is supplied. Best results are usually obtained with
the antenna in a vertical position.
Console port
DB9 female RS232 port.
This button has two (2) functions:
Reset Button
•
•
To Clear All Data and restore the factory default values:
1. Power Off the Access Point
2. Hold the Reset Button down while you Power On the Access
3. Continue holding the Reset Button until the Status (Red) LED
4. Release the Reset Button.
Ethernet
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub on your LAN.
Power port
Connect the supplied power adapter here.
Figure 3 Rear Panel
Reboot. When pressed and released, the Wireless Access Point
will reboot (restart).
Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
Point.
blinks TWICE.
The factory default configuration has now been restored, and the
Access Point is ready for use.
Introduction
5