LevelOne WAP-0005 User Manual page 45

Parameters
Disassociated Timeout
Fragmentation
Beacon Interval
RTS/CTS Threshold
Preamble Type
Output Power Level
Antenna Selection
802.11b
Protection Type
Short Slot Time
Protection Mode
Protection Rate
This determines how quickly a Wireless Station will be
considered "Disassociated" with this AP, when no traffic is
received. Enter the desired time period.
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Enter the preferred setting between 20 and 1000. Normally, this
can be left at the default value.
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Select the desired option. The default is "Long". The "Short"
setting takes less time when used in a good environment.
Select the desired power output. Higher levels will give a
greater range, but are also more likely to cause interference with
other devices.
If your Access Point has only 1 antenna, there is only 1 option
available. If your Access Point has 2 antennae, select the option
which gives the best results in your location.
Select the desired option. The default is CTS-only.
Enable or disable this setting as required.
The Protection system is intended to prevent older 802.11b
devices from interfering with 802.11g transmissions. (Older
802.11b devices may not be able to detect that a 802.11g
transmission is in progress.) Normally, this should be left at
"Auto".
Select the desired option. The default is 11 Mbps.
Setup
41