LevelOne WAP-0005 User Manual page 43

In PTMP mode, This is only functional if using Point-to-Multi-Point Bridge (PTMP)
only allow mode. If enabled, you can specify the MAC addresses of the APs
specified APs which are allowed to connect to this AP. To specify the allowed APs:
1. Enable this checkbox
2. Click the button "Set PTMP APs".
3. On the resulting sub-screen, enter the MAC addresses of the
Set PTMP APs Use this to open a sub-window where ou can specify the MAC
addresses of the APs which are allowed to connect to this AP. This is
only functional if using Point-to-Multi-Point Bridge (PTMP) mode and
you have enabled the checkbox "In PTMP mode, only allow specified
APs".
Parameters
•
Channel No
•
This displays the current channel used by the Access Point.
Current Channel
No.
allowed APs.
If "Automatic" is selected, the Access Point will select the best
available Channel.
If you experience interference (shown by lost connections and/or
slow data transfers) you may need to experiment with manually
setting different channels to see which is the best.
Setup
39