LevelOne WAP-0005 User Manual page 76

Wireless Access Point User Guide
Respond to Auto-
configuration request by
other AP
Provide login name and
password
Provide "Respond to
Auto-configuration"
setting
Auto Update
Check for Firmware
upgrade
Install...
FTP Server address
Firmware pathname
FTP Login Name
FTP Password
While firmware upgrading, no wireless connection is
allowed. Please must check before upgrading.
If checked, this AP will respond to "Auto Configuration"
requests it receives. If not checked, "Auto Configuration"
requests will be ignored.
If enabled, the login name and password on this AP is
supplied the the AP making the Auto-configuration request. If
disabled, the AP making the Auto-configuration request will
keep its existing login name and password.
If enabled, the "Respond to Auto-configuration" setting on
this AP is supplied the the AP making the Auto-configuration
request. If disabled, the AP making the Auto-configuration
request will keep its existing setting.
If enabled, this AP will check to see if a Firmware (FW)
upgrade is available on the specified FTP Server. If enabled:
•
Enter the desired time interval (in days) between checks.
•
Select the desired option for installation (see next item).
•
Provide the FTP server information.
Select the desired option:
•
Install FW if different version found
If selected, then if the firmware file at the specified
location is different to the current installed version, the
FW will be installed. This allows "Downgrades" -
installing an older version of the FW to replace the
current version.
•
Install later version only
If selected, then the firmware file at the specified location
will only be installed if it is a later version.
Enter the address (domain name or IP address) of the FTP
Server.
Enter the full path (including the FW filename) to the the FW
file on the FTP Server.
Enter the login name required to gain access to the FTP
Server.
Enter the password for the login name above.
72