Rear Panel - LevelOne 108Mbps PoE User Manual

Rear Panel

Antenna One antenna (aerial) is supplied. Best results are usually ob-
tained with the antenna in a vertical position.
Console port DB9 female RS232 port.
This button has two (2) functions:
Reset Button
•
•
To Clear All Data and restore the factory default values:
1. Power Off the Access Point
2. Hold the Reset Button down while you Power On the Access
3. Continue holding the Reset Button until the Status (Red)
4. Release the Reset Button.
Use a standard LAN cable (RJ45 connectors) to connect this
Ethernet
port to a 10BaseT or 100BaseT hub on your LAN.
Connect the supplied power adapter here.
Power port
Figure 3 Rear Panel
Reboot. When pressed and released, the Wireless Access
Point will reboot (restart).
Reset to Factory Defaults. This button can also be used to
clear ALL data and restore ALL settings to the factory de-
fault values.
Point.
LED blinks TWICE.
The factory default configuration has now been restored,
and the Access Point is ready for use.
5
Introduction