LevelOne WAP-0005 User Manual page 42

Wireless Access Point User Guide
AP Mode Both Bridge mode and AP mode can be used simultaneously, unless
AP mode is "Client/Repeater". Select the desired AP mode:
•
•
•
Note: If using Client/Repeater mode, you cannot use Bridge Mode.
REPEATER AP This is not required unless the AP Mode is "Client/Repeater". In this
MAC ADDRESS mode, you must provide the MAC address of the other AP in this field.
You can either enter the MAC address directly, or, if the other AP is
on-line and broadcasting its SSID, you can click the "Select AP"
button and select from a list of available APs.
If Disabled, no SSID is broadcast.
Broadcast SSID
If enabled, you must select the security profile whose SSID is to be
broadcast. This can be done the "Security Profiles" screen. The SSID
will then be broadcast to all Wireless Stations. Stations which have no
SSID (or a "null" value) can then adopt the correct SSID for
connections to this Access Point.
Both Bridge mode and AP mode can be used simultaneously, unless
Bridge Mode
AP mode is "Client/Repeater". Select the desired Bridge mode:
•
•
•
If required, you can specify the MAC addresses of the APs which are
allowed to connect to this AP in PTMP mode. To specify the allowed
APs:
1. Enable the checkbox "In PTMP mode, only allow specified APs".
2. Click the button "Set PTMP APs".
3. On the resulting sub-screen, enter the MAC addresses of the
PTP Bridge AP This is not required unless the Bridge Mode is "Point-to-Point Bridge
MAC Address (PTP)". In this case, you must enter the MAC address of the other AP
in this field.
None (disable) - Disable AP mode. Use this if you want to act a
Bridge only.
Access Point - operate as a normal Access Point
Client/Repeater - act as a client or repeater for another Access
Point. If selected, you must provide the address (MAC address) of
the other AP in the Repeater AP MAC Address field. In this
mode, all traffic is sent to the specified AP.
None (disable) - Disable Bridge mode. Use this if you want to act
a AP only.
Point-to-Point Bridge (PTP) - Bridge to a single AP. You must
provide the MAC address of the other AP in the PTP Bridge AP
MAC Address field.
Point-to-Multi-Point Bridge (PTMP) - Select this only if this AP
is the "Master" for a group of Bridge-mode APs. The other
Bridge-mode APs must be set to Point-to-Point Bridge mode,
using this AP's MAC address. They then send all traffic to this
"Master".
allowed APs.
38