Connections To The Rs-1100; Connector Panel Access; Connecting The Sdc-1 System Expansion Device To The Rs-1100 - Runco RS-1100 CineWide Owner's Operating Manual

Proceed as follows to connect the RS-1100 to your video sources, external controller(s) –
if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
To access the connector panel, pull
firmly on the cable access cover to
open it.
If (and ONLY if) your installation includes an SDC-1 System Expansion Device:
Use a Runco R-Link cable to connect the SDC-1 output to the RS-1100 R-Link input; see
Figure 3-8.
All signal sources should then be connected to the appropriate inputs on the rear panel of
the SDC-1. The signal from the SDC-1 is then output to the RS-1100 projector via the
R-Link cable. For detailed instructions, refer to the SDC-1 Owner's Operating Manual.
Connect ONLY an SDC-1 to the R-Link input! Although the
Note
R-Link looks like a DVI input, it does not function like one and
cannot be used as an additional video input.
R-LINK IN
(from SDC-1 Controller
R-Link Output to Projector
R-Link Input)
INPUT FROM SDC-1
RS-1100 Connector Panel
Serial No
Runco International
Union City, CA
BOTH OUTPUTS MUST BE
CONNECTED TO PROJECTOR
SDC-1
SYSTEM EXPANSION DEVICE
OUTPUTS TO
PROJECTOR
Figure 3-8. Connecting the RS-1100 to the SDC-1
Runco RS-1100 Series Owner's Operating Manual
HD-1 INPUTS
V H B
HDMI / DVI
2 1
V H B
DIGITAL
INPUTS
HD-2 INPUTS
SDC-1 Rear Panel
S-VID /
VIDEO T
G R
G R
S-VIDEO
25
Installation
3.6
Connections to the
RS-1100

Connector Panel Access

Connecting the SDC-1
System Expansion Device
to the RS-1100