Kurzweil PC3LE Musician's Manual page 87

The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read Algorithm Basics on page 6‐28 and Common DSP Control
Parameters on page 6‐29.
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which is
displayed below:
Parameter
Source 1
Depth
Source 2
Depth Control
Minimum Depth
Maximum Depth
Each field in the left‐hand column of the page is a function‐parameter of the current layer's
algorithm. You can coarsely adjust the function‐parameter in these left‐hand fields—as noted in
Common DSP Control Parameters, any adjustments made to the function‐parameters on the
DSPMOD page are reflected in the corresponding function‐parameters on the DSPCTL page.
The right‐hand side of the DSPCTL page is the subpage of the highlighted function‐parameter—
on the subpage are the programmable parameters. To access the parameters on the subpage,
highlight the function‐parameter you wish to edit, and then press the > button to move the
cursor into the subpage.
Each function‐parameter's subpage contains the programmable parameters of the highlighted
function‐parameter. By assigning control sources to modulate a function‐parameter, you can
enable real‐time control of your program's sound and behavior. You can assign Src1 to any
control source, and can specify its maximum value with the Depth parameter. Src2 is different—
you can assign it to any control source, but can also assign a control source to its maximum
value with the DptCtl parameter. You can then specify the range of Src2's depth with the
MinDepth and MaxDepth parameters.
Note: The PC3LE features an easy shortcut for quickly assigning any of the PC3LE's realtime controllers
(knobs, wheels, buttons, etc.) to a currently selected parameter (such as the Src1 and Src2 parameters
above.) With a source parameter field selected, simply hold the Enter button and move the desired
controller to select it as a control source.
The label of a function‐parameter depends on its corresponding function‐block in the current
layer's algorithm. The above DSPMOD page corresponds to the following algorithm:
Range of Values
Control Source List
(Depends on Function)
Control Source List
Control Source List
(Depends on Function)
(Depends on Function)
Default
Off
0
Off
Off
0
0
Program Mode
The Program Editor
6-35