Kurzweil PC3LE Musician's Manual page 212

Master Mode
MIDI Transmit (XMIT)
Program Change (ProgChange)
When ProgChang is set to On, the PC3LE sends program change commands to its USB or MIDI
Out port when you select programs or setups from the front panel or from your MIDI controller.
Select a value of Off when you want to change programs on the PC3LE but don't want to send
program change commands to the USB or MIDI Out port. This parameter doesn't affect the type
of program change command that's sent; it just determines whether any command is sent at all.
(The type of program change command is determined by the BankMode parameter on the CH/
PROG page in the Setup Editor of your control setup. See The Setup Editor on page 7‐5 for more
details.)
Note: The ProgChang parameter applies to all modes except Song mode and Setup mode (or when a setup
is loaded from Quick Access mode.) Setups disregard the ProgChang setting and instead use the
EntryProgChg parameter on the SetupMode:CH/PROG page (See The Channel/Program (CH/PROG)
Page on page 7‐6.) Songs disregard this ProgChang setting and instead use the ProgChang parameter on
the Song:Event Filter Playback page, accessed from the PLYFLT soft button in Song mode.
Change Setups (ChgSetups)
This parameter determines the exact timing of setup changes when you select a different
setup—either by a normal data entry method or via MIDI program change commands. Choose
KeyUp to indicate that you want setup changes to take place only when you've released all
currently held notes. Choose Immediate to indicate that you want such changes to happen
immediately when you select the setup.
9-16