Kurzweil PC3LE Musician's Manual page 336

Tutorials: Setup Mode
Creating A New Setup
7.
8.
When saving, you must choose an ID#. An ID# gives you a way to locate a setup aside from its
name (you can store up to 2,560 unique ID#s for each object type: setups, programs, songs, etc.,
though many ID#s are already used for factory ROM objects.) ID#s also allow you to save setups
with the same name under different ID#s, and rename them at a later time if desired. Choose an
unused ID# to save a new setup. The next available unused ID# is automatically selected when
editing a factory ROM setup. When editing a setup that has been stored in user memory (any
originally unused ID#,) the edited setup's ID# is automatically selected. This assumes that you
wish to replace the existing setup, but you can choose another ID# if desired to save a new copy.
Choose a used ID# to replace an existing saved setup. If you replace a factory ROM setup, you
can revert to the original setup by using the Delete soft button in the Setup Editor. See
Chapter 5, Editing Conventions for more details on saving and naming.
14-34
If you would like to adjust the keyrange of each Zone, use the more soft buttons on the bottom of
the display to scroll to through pages of soft buttons and find and press the KEYVEL button. This
brings you to the KEY-VEL page where you can view the key range for the current Zone (see
below.) You can view the number of the selected Zone in the top right corner of screen. Use the
Chan/Zone buttons to the left of the display to select the current Zone. On the KEY-VEL
page, the LoKey and HiKey fields set the lowest and highest keys that will trigger the current
Zone. All keys in between the LoKey and HiKey will trigger the current Zone, while those outside
of this range will not trigger the current Zone. To set a key value for the LoKey or HiKey field,
select the field, hold the Enter button on the alphanumeric pad and press the desired keyboard key.
When you are finished creating your setup, press the Exit button on the front panel to exit the
Setup Editor and return to the Setup mode main page. You will be presented with the message
"This setup has been edited..." Press Rename to save and name your setup, press No to return to
the Setup mode main page without saving, or press Cancel to return to the Setup Editor.