Kurzweil PC3LE Musician's Manual page 188

Setup Mode
The Setup Editor
Delete Zone (DelZn)
This deletes the current zone from the setup. Use DelZn to free up zones so you can add or
import new ones.
Set Controls KB3 (KB3CTL)
Press this button if you want to assign the setup's knobs and switches to control organ functions
(if you have a KB3 organ program in the current setup.) Organ functions for KB3 programs are
labeled on the front panel under the switches and knobs. When you press the KB3CTL soft
button, you will be prompted to continue by pressing OK, or to cancel and return to the
previous screen by pressing CANCEL. Caution: This will clear any existing knob or switch
assignments.
For setups with KB3 and V.A.S.T. programs, you can program a switch to toggle back and forth
between having the knobs and assignable switches function as they would with KB3 programs,
or having the switches function as zone mute buttons. To do this, in the Setup editor, first use
the KB3CTL soft button as explained above. Next, go to the Controllers page (by pressing the
CTRLS soft button.) On the Controllers page, select the Controllers field, hold the Enter button
on the alphanumeric pad and press the ArpLatch button (above the Mod Wheel) to choose Arp.
latch sw for the controller field (alternatively the Arp Enable button (Arp. switch) can be used.)
On the Controllers page for Arp. latch sw, use the cursor buttons to select the DestType field
and set it to Ctrl. Next, select the OnControl field and set it to KB3Mutes by entering 169 and
pressing the Enter button on the alphanumeric pad. Do the same for the OffControl field. Leave
the other fields at their defaults: Type=Toggled, OnValue=127, OffValue=0. Make these Controller
page settings for all zones in the setup. Now when you press and light the ArpLatch button the
assignable switches work as zone mute buttons (see below.) When you press and unlight the
ArpLatch button the assignable switches work as KB3 controls. Make sure to save your setup to
keep these changes. Caution: This will clear any existing knob or switch assignments.
Set Controls Zone Mutes (MUTES)
Press this button if you want to assign the setup's switches to control zone muting. Switches 1
through 10 will mute zones 1 through 10 respectively. A switch with a lit LED means it
respective zone is active, a switch with an unlit LED means it respective zone is muted. When
you press the MUTES soft button, you will be prompted to continue by pressing OK, or to cancel
and return to the previous screen by pressing CANCEL. Caution: This will clear any existing
switch assignments.
7-66