Kurzweil PC3LE Musician's Manual page 117

PercLevel, DecayTime, OrgLevel
With these parameters you can control the amplitude and decay time of the percussion effect for
all combinations of the Volume and Decay parameters (on the PERC1 page). You can also adjust
the level of the organ relative to the percussion, for accurate emulation of classic organs.
KB3 Editor: The KEYCLK Page
The Key Click feature adds a decaying burst of pitched noise to the attack of notes. Unlike the
percussion, the key click is "multi‐triggered," which means that every new note will trigger it.
The parameters on this page primarily control the decay, volume, and pitch of the key click.
Parameter
Key Click
Volume
Decay
VelTrk
Pitch
Random
Retrig Thresh
Note Attack
Note Release
KeyClick
This is where you turn Key Click on or off. With KeyClick set to Off, you may still hear a click
depending on your Note Attack and Note Release settings (see below.) You can turn key click
on or off by pressing Assignable Switch 10 (SW10) (labeled Click On/Off.) Assignable Switch 10
also sends and responds to MIDI CC 90; values 64‐127 = On, values 0‐63 = Off.
Volume
This parameter sets the level of the keyclick; the noise decays from the level you set here. This
level is scaled by the drawbar levels, as well as the expression pedal level.
Decay
Sets the basic decay time of the noise envelope. Smaller values produce a shorter burst.
Range of Values
Off, On
-96.0 to 0.0 dB, in 0.5-dB increments
0.005 to 1.280 seconds, in 0.005-second increments
0 to 100%
1 to 120
0 to 100%
-96.0 to 0.0 dB, in 0.5-dB increments
Normal, Hard, PercHard
Normal, Hard
Program Mode
The Program Editor
6-65