Kurzweil PC3LE Musician's Manual page 320

Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
7.
Knob 1 (labeled Timbre on the front panel) should now control the volume of the pad on Zone 2,
222 Class Pad (if not, review the previous steps.)
8.
9.
10. With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field
14-18
With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest
field, press 7 and then the Enter button on the alphanumeric pad to choose Volume (see below.)
You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.
Next, lets repeat the steps above for Zone 3, except this time we will set an offset so that Zone 3 is
always quieter than Zone 2. On the Controllers page, use the Chan/Zone buttons to the left of the
display to select Zone 3 (see below.) You can view the number of the selected Zone in the top right
corner of screen.
On the Controllers page for Zone 3, Knob 1 will still be selected in the Controller field. If not,
follow these steps: Use the cursor buttons to select the Controller field. Make sure the LED to the
left of Timbre Knob is lit, if it is not, press the Shift button to the left of the Knobs until that LED
is lit. Next, hold the Enter button on the alphanumeric pad and move the Knob labeled Timbre.
This will select Knob 1 for the Controller field. You can also set the desired controller in the
Controller field by using the Alpha Wheel or - / + buttons.
and then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)