Kurzweil PC3LE Musician's Manual page 305

Tutorials: Setup Mode
The Setup Editor
The Setup Editor
In each of the following guides, you will be using the Setup Editor to make changes to the currently
selected setup. Open the Setup Editor from Setup mode by pressing the Edit button on the front panel.
Use the soft buttons at the bottom of the display to select the various Setup Editor pages. Use the more
soft buttons on the bottom of the display to scroll through pages of soft buttons. The top line of the
display says "SetupMode:" with the name of the current Setup Editor page as well as the
number of the current Zone. Use the Chan/Zone buttons to the left of the display to select the
current Zone. The current and total number of Zones can be viewed in the upper right corner of
each screen in the Setup Editor.
Press the Exit button on the front panel to exit the Setup Editor and return to the Setup mode main page.
If you have made any changes to the setup, you will be presented with the message "This setup has been
edited..." (see below.) You are given a choice of soft buttons: Press Rename to rename the setup before
saving, press No to return to the Setup mode main page without saving, press Yes to choose an
ID# and save the setup, press Cancel to return to the Setup Editor.
About ID#s
When saving, you must choose an ID#. An ID# gives you a way to locate a setup aside from its
name (you can store up to 2,560 unique ID#s for each object type: setups, programs, songs, etc.,
though many ID#s are already used for factory ROM objects.) ID#s also allow you to save setups
with the same name under different ID#s, and rename them at a later time if desired. Choose an
unused ID# to save a new setup. The next available unused ID# is automatically selected when
editing a factory ROM setup. When editing a setup that has been stored in user memory (any
originally unused ID#,) the edited setup's ID# is automatically selected. This assumes that you
wish to replace the existing setup, but you can choose another ID# if desired to save a new copy.
Choose a used ID# to replace an existing saved setup. If you replace a factory ROM setup, you
can revert to the original setup by using the Delete soft button in the Setup Editor. See
Chapter 5, Editing Conventions for more details on saving and naming.
14-3