Kurzweil PC3LE Musician's Manual page 332

Tutorials: Setup Mode
Switch Between Zones Based On Played Keyboard Velocity
4.
5.
6.
Step 7
7.
Now both Zones 2 and 3 will only respond to velocities of 80 or more. Try playing some soft
quiet notes, you should hear only piano. Next, play some hard loud notes, and you should hear
the piano and pads (if not, review the previous steps.) Depending on your playing style, you
may wish to set the LoVel value for Zones 2 and 3 lower or higher so that Zones 2 and 3 can be
triggered by lower velocities or only very high velocities.
14-30
On the KEYVEL page, use the Chan/Zone buttons to the left of the display to select Zone 2 (see
below.) You can view the number of the selected Zone in the top right corner of screen.
On the KEYVEL page for Zone 2, use the cursor buttons to select the LoVel field. Then press 80 on
the alphanumeric pad and press the Enter button to enter 80 for the LoVel field (see below.) This
means that 80 is the lowest keyboard velocity that Zone 2 will respond to, anything lower will not
cause Zone 2 to be heard. Any velocity of 80 or more will cause Zone 2 to be heard because Zone
2's HiVel field is set to 127, which is the maximum MIDI velocity.
Next, lets set the same velocity range for Zone 3. Use the Chan/Zone buttons to the left of the
display to select Zone 3 (see below.) You can view the number of the selected Zone in the top right
corner of screen.
On the KEYVEL page for Zone 3, the LoVel field will still be selected if you haven't moved the
cursor. If the LoVel field is not selected, use the cursor buttons to select the LoVel field. Then press
80 and press the Enter button on the alphanumeric pad to enter 80 for the LoVel field (see above.)
Step 6