Install The Lamp - Christie DHD600-G User Manual

4.12

Install the Lamp

The projector automatically detects the lamp life. When the lamp life is
nearing the end of use, you will receive a warning message. "When you see
this message, please change the lamp as soon as possible." Make sure the
projector has been cooled down for at least 30 minutes before changing the
lamp.
Installation Steps:
1. Turn off the lamp: Turn the projector OFF and disconnect the power cord.
2. Wait for lamp to cool down: Allow the projector to cool down for at least 30 minutes.
3. Open the lamp door: Push the door latch to open lock.
Loosen the captive screw securing the lamp door. Open the lamp door.
G Series User Manual
020-000648-01 Rev. 3 (02-2014)
Section 4: Operation
4-41