Table of Contents
Advertisement
4.4
Lamp Menu
Lamp Mode
Select Constant Power, Constant Intensity or ECO mode. When in ECO
mode, the projector will adjust to the lowest fan speed and switch the lamp
power to the minimum setting.
Constant Power
Set the value of the lamp power (in Watts).
Constant Intensity
Set the value for the Constant Intensity to maintain constant brightness.
The light sensor will monitor the light level and will apply more power as the
lamp brightness decays naturally over time. When the lamp setting reaches
maximum power of 370W, it will remain at this setting. Note that the light
sensor needs to be calibrated for Constant Intensity mode to work properly.
Calibration should be performed again after every lamp change.
Lamp Info
Display current lamp(s) settings (read-only).
Lamp Life Setting
Set the number of hours for the lamp life warning. After the lamp hours exceed
this value, a lamp replace message will appear. Once the lamp hour exceeds
the value of " Lamp Life Settings", a warning message box will be shown on
screen and the Lamp LED will be solid yellow at the same time.
Reset Lamp Hours
Reset the lamp used hours counter to zero. Do this after changing the lamp.
Light Sensor
Calibrate light sensor.
G Series User Manual
020-000648-01 Rev. 3 (02-2014)
Section 4: Operation
4-15
Hide quick links:
Advertisement
Table of Contents
