Led Status Indicators - Christie DHD600-G User Manual

Section 2: Introduction
2.5

LED Status Indicators

The LED status indicators are located on the right side of the projector. Each
LED is defined below.
y
LAMP LED
Red (short blink)
Yellow (no blink)
Green (no blink)
Green (short blink)
Off
y
STATUS LED
Off
Off, but keypad LED
is on
Green (no blink)
Flashing Yellow
Flashing Green/
Yellow
Red (short blink)
Red (no blink)
Green (blink very
quickly)
2-8
LED Status
Failed to strike lamp after 5 attempts (strike attempts will
stop).
Lamp has unexpectedly shut down (system goes into cool
down state).
Lamp time has expired and lamp should be replaced.
(projector also begins to display the replace lamp OSD
message at startup).
Lamp is ON and operating correctly
Projector lamp is switching on
Lamp is off
LED Status
Projector is in OFF state (without AC plug in)
Projector is in standby mode (AC plug in)
Projector is powered up and operating normally
Projector is in cool down mode or startup mode
Projector is in flash update state
Fan failure
Over-temperature
Projector communications (Read/Write EEPROM)
Projector State
Projector State
G Series User Manual
020-000648-01 Rev. 3 (02-2014)