Size Switch Error - Fisher & Paykel SmartDrive Service Manual

8. (00001000) Phase 1 - Display Module Fault
The Display Module micro has not been able to start up correctly.
Primary Source:
Action:
9. (00001001) Phase 1 to 6 - Size Switch Error
The Display Module size switch setting does not match that stored in
the memory.
Primary Source:
Action:
Secondary Source: Motor Control Module.
Action Phase 1, 2 &3:
Action Phase 4 Series 8, Phase 5 Series 9 & Phase 6 Series 11:
Display Module.
Turn off at the wall and on again after 5 seconds
and try again. If still faulty replace the Display
Module.
Display Module Phase 1,2 & 3.
If the Display Module for Phase 1, 2 or 3 has
just been inserted into a console housing, then
check that the two size switch plungers
accurately locate onto the console housing. If
this fault has appeared during normal operation
of the SmartDrive, check for condensation
damage, check the size switch or replace the
Display Module.
If the Motor Control Module has been changed
from one size SmartDrive to another, then the
size switch settings in the memory will have to
be reset. This can be done by entering and
exiting the Option Adjustment mode. Push and
hold START/PAUSE then push the POWER
button.
Reselect the size of the SmartDrive by using the
SIZE SETTING MODE.
WATER TEMP UP button then press the
POWER button.
SmartDrive, push the TEMPERATURE UP
button until the cold LED is on for 5kg
SmartDrives, push the WATER LEVEL UP
button until the low water level LED is on for the
6kg SmartDrives, push the SPIN SPEED UP
23
Push and hold the
To select the size of the