Wash Water Temperature – All Phases; Method Of Setting The Wash Temperature; To Select The Option Adjustment Mode - Fisher & Paykel SmartDrive Service Manual

To Select the OPTION ADJUSTMENT MODE

1. With Smartdrive powered on at the wall and with the LEDs off, press and
hold the START/PAUSE button. Then press the POWER button. Two
quick beeps will sound and the LEDs on the front panel will change. The
controls and LEDs on the front panel will now serve different functions
from the normal wash functions.
2. Smartdrive can now be adjusted to suit the owners preference.
3. To return Smartdrive to Normal operation, press the POWER button.
Wash Water Temperature – All Phases
It is possible to adjust the water temperature of each of the wash temperature
settings, i.e. Cold, Cold/Warm, Warm, Warm/Hot, Hot. Phase 5 MW can only
adjust warm. Phase 5 LW & AW are not adjustable.
Do not use the household water taps or water heater controls to vary the
wash temperature. The automatic water temperature control system fitted will
compensate for variations in household water temperature and pressure.
Adjusting the water pressure or water flow with the household taps, or
adjusting the water heater temperature, WILL NOT alter the wash
temperature. The method described below is the only method by which the
water temperature can be altered. If Smartdrive is used in an installation
where only a cold water supply is available, then the cold temperature range
must be selected and the "cold water only" setting must be chosen in the
option adjustment mode. If the temperature is set at any other level,
Smartdrive will expect hot water when filling Smartdrive. As it will not detect
any hot water, it will eventually display USER WARNING that there is no hot
water, but it will not pause. It is recommend that the hot water temperature
setting on the household water heater does not exceed 65oC, for personal
safety and product reliability. This is especially important for Phase 5 MW,
LW & AW where the 'Hot' setting corresponds to hot water only.

Method of Setting the Wash Temperature

1. Select the OPTION ADJUSTMENT MODE by pressing and holding the
START/PAUSE button, then pressing the POWER button.
2. Use WASH TEMPERATURE buttons and LEDs to select the temperature
setting to be adjusted, i.e. Cold, Cold/Warm, Warm, Warm/Hot, Hot.
9