Table of Contents
Advertisement
If the size setting is wrong, SmartDrive will have the following settings
incorrect:
• The Auto Water Levels chosen by SmartDrive may be wrong.
• The High Water Level may be wrong by as much as 40mm.
• The flow rate for inlet water, normally 3 litres per minute, may be set
incorrectly.
• The wash profile controls the strength of the agitator stroke. This could
result in poor wash performance or splash over.
• Water saver settings.
DIAGNOSTIC MODE
Turn the power on at the power point but off at the machine. Press and hold
the WASH TEMP DOWN button and then the POWER button until the
machine gives 2 short beeps and lights up. Release buttons when the beeps
indicate diagnostic mode has been entered.
The SmartDrive is now in diagnostic mode. To obtain the last fault code,
(Phases 1, 2 and 3 only, press the ADVANCE button once, then) press the
SPIN SPEED UP button three times so that the Hold and Slow LEDs are
illuminated. The eight wash progress LEDs will now show the last fault in a
binary code. On LW models, there is no window for the Long Wash LED, but
the LED is still visible under the panel for diagnostic purposes. The value of
each LED is shown below. Add up the value of the LEDs illuminated to
obtain the fault code number, then refer to the Detailed Fault Codes section
of this manual.
WASH
15 Min.
PROGRESS
Long
Wash
VALUE
128
12
9
6
Min.
Min.
Min.
64
32
16
5
3 Min.
Rinse
Final
Short
Rinse
Wash
8
4
Spin
2
1
Hide quick links:
Advertisement
Table of Contents
