Fault Descriptions; Display Module Fault; Motor Control Module Fault; Communications Fault - Fisher & Paykel SmartDrive Service Manual

1. (00000001) Phase 1 - Display Module Fault
The Motor Control Module (Display Module for Phase 1) has
encountered an error when writing to an EEPROM address.
Primary Source:
Action:
2. (00000010) Phase 1 - Display Module Fault
An error has been encountered when trying to read the pressure
sensor.
Primary Source:
Action:
3. (00000011) Phase 1 to 6 - Motor Control Module
The Motor Control Module has found a memory error.
Primary Source:
Action:
4. (00000100) Phase 1 - Communications Fault
The Motor Control Module has had difficulty communicating with the
Display Module.
Primary Source:
Action:

FAULT DESCRIPTIONS

Phase 2 to 6 - Motor Control Module
Fault
Motor Control Module.
Phase 1.)
Replace Motor Control Module.
Module for Phase 1.)
Phase 2 to 4 - Motor Control Module
Fault
Motor Control Module.
Phase 1.)
Replace Motor Control Module.
Module for Phase 1.)
Fault
Motor Control Module.
Replace Motor Control Module.
Motor Control Module.
1. Turn off at the wall and on again after 5
seconds and try again.
2. If still faulty, replace the Motor Control
Module.
3. Replace Display Module. If the new Display
Module corrects the fault, then refit the
original Motor Control Module.
21
(Display Module for
(Display
(Display Module for
(Display