Cleansmart 685; Size Setting; Installation Test - Fisher & Paykel 685 Service Manual

CLEANSMART 685

Size setting

When a motor control module is replaced the machine when powered on will
display fault code 9 (required to be size set).
To select Machine Size
6 8 5
With the console Off Press & Hold Key Lock and Spin for 3 Sec. Size Setting Mode
To set the size:
Turn the mains on at the supply point and off at the display.
Touch and hold the KEYLOCK and the Spin buttons for 3 seconds
until the LED display shows the current setting of "- - -" or "685".
To select the size touch the MORE Button and "685" will display in the
LED display.
To save the setting power off the console with the Power button, your
selection is automatically saved.

Installation Test

Correct installation of the 685 washer is very important to the performance of
the machine especially the dynamics of the spin cycle. To aid with the
installation an install procedure P/No 421700 is attached on the top of the lid
of each machine, as part of this procedure there is an installation test routine
that checks the water inlet hot & cold, drain and low speed spin of the
machine. The test routine will take approximately 3 to 10 minutes depending
on the supply water pressure.
With the console On Press & Hold Key Lock and Options for 3 Sec. Installation Mode
5